Mastercam 2017 For Solidworks Tutorial (lathe) Info

This is critical. You need to tell Mastercam the size of the raw bar stock. Use the "Make from 2 points" or "Cylinder" options. Don't forget to add a little extra on the face for a facing cut and enough "meat" in the back for the chuck jaws to grab! 3. The Facing Operation Always start by cleaning up the face of the part. Select Lathe Face .

Once the bulk of the material is gone, use Lathe Finish . This will use a smaller tool (like a 35-degree DNMG) to follow the exact contour of your SOLIDWORKS geometry. 5. Parting Off The most nerve-wracking part of any lathe job! Select the Lathe Cutoff toolpath. Choose your parting tool width carefully. Mastercam 2017 for SOLIDWORKS Tutorial (Lathe)

In the parameters, ensure you have a "Lead In" and "Lead Out" so the tool doesn't just plunge straight down into the material. 4. Roughing and Finishing This is where the shape happens. This is critical